This board is designed to allow you to extend four outputs over one Ethernet cable. It is recommended that you use a shielded cable for these boards to provide a ground return. Nominally the forums use these boards without the ground, which assumes that a ground return will exist through the AC power lines. For more information plese visit: Single Cable...
The standard output board supports all pixel output types. Each boards supports eight outputs with fusing and power inputs on either side. The output termination resistor should be a nominal 100 ohms. For more information plese visit: Fused Standard Output
The Renard Plus ESP WiFi Pixel controller kit is our take on a very inexpensive way to control pixels using a Wireless router. Our board can be configured for both 5 volt or 12 volt pixels, uses all through parts (included with the kit) and the radio module is even INCLUDED. What a bargin. Our documenttion for this product can be found here here
The Renard Plus DCSSRhc is a 4 channel DC (direct current) SSR relay board that supports standard Renard Protocol from a controller such as the Renard Plus 32. The board is rated at 10 amps so it should provide plenty of options.